Vietnam's Ministry of Industry and Trade opened an anti-dumping investigation on 6 November 2026 into cold-rolled stainless steel from China, Indonesia and Taiwan. Decision 2948/QĐ-BCT gives the case the code AD25 and takes effect on the day it was issued. It sets no duty. Two producers in Vietnam asked for the case, and the figures in it so far are theirs, not the ministry's.1 2
What the petition alleges
An anti-dumping duty is a charge a government may add when it finds that foreign goods are sold below their normal value and that this harms its own producers. The petitioners are Posco VST Co., Ltd. and Tân Việt Metal Science and Technology Co., Ltd., which the ministry accepts as representing the domestic industry. The notice attached to the decision says they supplied data putting the dumping margin at 76.6% for China, 75.5% for Indonesia and 51% for Taiwan.1
A footnote in the notice limits what those numbers mean.
Mức thuế này là cáo buộc của Bên yêu cầu, không phải là kết luận của Cơ quan điều tra.
This rate is the allegation of the petitioner, not the conclusion of the investigating authority.1
The notice says the Trade Remedies Authority, the ministry's investigating body, confirmed on 29 September 2026 that the petition was complete and valid. On the same day it wrote to the Chinese and Indonesian embassies and to the Taipei Economic and Cultural Office in Vietnam to tell them so. The notice says the authority found that the petitioners represent the domestic industry and that there was clear evidence that dumped imports cause material injury, which is the legal threshold for opening a case and not a final finding.1
What is covered
The goods are stainless steel in coil, sheet or strip that has been cold-rolled, is no more than 3.5 mm thick, and has been annealed or not. They fall under nine tariff codes in headings 7219 and 7220. Products thicker than 3.5 mm, clad or laminated products, and products plated with another metal are left out.1
The authority will measure dumping over 1 October 2025 to 30 September 2026, and injury to Vietnamese producers over 1 October 2022 to 30 September 2026.1
Duties on the same codes ran from 2014 to 2024
Vietnam has investigated this product before. That case, coded AD01, was opened on 2 July 2013 against China, Indonesia, Malaysia and Taiwan, on a complaint by Posco VST and another producer, Inox Hoa Binh. The case summary kept by the WTO Center of the Vietnam Chamber of Commerce and Industry lists the same nine tariff codes.4
The duties set in September 2014 were far below the margins now alleged: 4.64% to 6.87% for China, 3.07% for Indonesia, 10.71% for Malaysia and 13.79% to 37.29% for Taiwan. A review in 2016 raised China's rates to 17.47% and 25.35%, and the measure was extended for five years in October 2019. On 12 November 2024 the ministry issued Decision 3011/QĐ-BCT, which ended the measure after a second expiry review without extending it.4
The new decision is dated just under two years after that one. Malaysia, covered by the old duties, is not named in the new case.1 4
Japan acted on cold-rolled stainless steel six days earlier
Vietnam is not the only importer in the region to move against this product in recent weeks. China's Commerce Ministry runs a trade-remedy information site that tracks cases against Chinese exporters. It reported that Japan's Finance Ministry imposed final anti-dumping duties on cold-rolled stainless steel from mainland China and Taiwan from 31 October 2026, for five years. It gives the rates as 27.7% to 42.1% for mainland Chinese producers and 3.6% to 20.1% for producers in Taiwan, in force until 30 October 2031.5
This site scanned the same Chinese government site's notices for early November and did not find one on the Vietnamese case. It also did not find a public response from the Chinese, Indonesian or Taiwanese authorities in the pages it read.
What happens next
Foreign producers and exporters have been sent a sampling questionnaire, issued under a notice of 13 November 2026. Replies must reach the authority through its online system by the end of 30 November 2026, Hanoi time. Firms that do not reply on time, or reply incompletely, are treated as not co-operating.3
Importers, distributors and users of the steel can register as interested parties. The ministry gives the last day as 5 January 2027.2
A provisional duty is possible after a preliminary conclusion, and the notice says it may not exceed the margin found at that stage. If the final conclusion finds material injury or a threat of it, the minister may also apply duties to goods imported in the 90 days before a provisional duty, provided the goods were dumped and imports surged after the case opened and caused injury that is hard to repair. The ministry says it will hold a public consultation before its final conclusion. None of the documents read gives a date for the preliminary conclusion.1 2