The US Federal Communications Commission's latest equipment-approval rules took effect on 13 October 2026. They can block authorisation of a finished device because of a component produced by a named Covered List entity, even when another company supplies the finished product.1
The test concerns logic-bearing hardware, meaning digital or radiofrequency components performing specified functions. It applies where the complete device would itself be prohibited if the listed entity had produced it. Purely mechanical or passive parts are excluded. The commission declined to extend this rule to software, firmware or every component from any foreign-adversary-controlled company.1
The component restriction applies prospectively to new applications. Existing authorisations are unaffected by this particular provision, while pending applications are exempt unless later changed to add, substitute or alter relevant components. It therefore requires attention to the application and product design, rather than treating every installed device as newly prohibited.1
Online sales have a separate timetable
China's Academy of Information and Communications Technology highlighted the rule for suppliers in a September regulatory update. It identifies staged obligations for online platforms to display devices' FCC identification numbers: March 2027 for platforms with physical control of the goods and June for those without it. It also reports that named Covered List entities must obtain full recertification when modifying equipment, instead of using a simplified change procedure.2
The academy describes the requirement as:
完整重新认证
Full recertification.2
Its update puts the FCC's estimated one-off implementation cost at up to US$300 million, mainly for displaying identification numbers online. This is a regulatory cost estimate, not evidence of losses already suffered by importers or a measured reduction in electronics trade.2
Maintaining installed products is a different decision
China's Commerce Ministry trade-information service separately described a May FCC waiver permitting software and firmware maintenance for previously authorised foreign-produced drones, drone components and consumer routers until 1 January 2029. The eligible devices must have obtained authorisation before their addition to the Covered List.3
The service says the waiver covers basic functionality, security fixes and compatibility with operating systems and networks. It explains the security concern created if suppliers cannot patch deployed equipment. It also stresses that this relief does not remove devices from the list or withdraw the broader restrictions. Permission to maintain an installed product consequently should not be read as permission to launch an unapproved new model.3
Beijing contests the wider policy direction. Responding on 1 May to separate proposed FCC measures concerning testing bodies and telecommunications operations, China's Commerce Ministry accused Washington of discriminatory treatment and overstating security concerns. It warned of disruption to international supply chains and asked for withdrawal. That statement addressed those earlier proposals; it was not a ruling on the legality or effect of the later component rule.4
The next scheduled marketplace milestones are the differentiated March and June 2027 implementation dates, requiring platforms to determine which category applies to their listings.2